Voice Agent
Manage

Configure outbound calling

Configure, test, start, and stop the outbound calling service.

The Settings page configures the outbound calling connection used by applicable Real Call workflows. It also exposes controls for the locally managed telephony services. The page is available only to a super-admin.

Keep credentials out of these fields. Voice Agent expects service addresses and phone numbers here; provider secrets belong in the deployment's protected configuration.

Review the current service

Open Sidebar → Settings. Under Outbound Calls (Twilio), review the service status and configured server address.

Select Refresh to request the current status. A stopped or unreachable service cannot complete an outbound Real Call even when the AUT itself is registered correctly.

Configure the connection

Review the fields under Configuration:

  • Server URL — the address of the outbound calling service.
  • Default TA Number — the Test Agent phone number used when Runner does not ask for one explicitly. Enter it in E.164 format.
  • URL — the approved public address for the telephony environment. Voice Agent may prefill this field in a deployed environment; confirm the expected value with the deployment or telephony owner.

Select Save to persist the configuration. Test Connection sends a health request to the saved Server URL; it does not validate the public URL or either phone number. After the check, select Refresh and confirm that the service status is Running instead of relying on the notification alone.

Start or stop the service

When the status is stopped, Start Server can start the complete locally managed telephony stack, including inbound, outbound, routing, and tunnel services. Stop Server can stop that same stack. Use these controls only when no phone-based Real Calls are active and local service management is appropriate for the environment. Refresh the status after either action.

Starting or stopping this service is different from registering an AUT phone number. Manage the AUT's number on Agents.

If the connection test fails

  1. Confirm that Server URL points to the intended environment.
  2. Save any correction and select Test Connection.
  3. Select Refresh and confirm that the service reports Running.
  4. If the service is running but a call still fails, verify the approved public URL and Default TA Number with the deployment or telephony owner.

Do not repeatedly submit Real Calls while the service is stopped or its connection test is failing.

Choose a supported testing mode

Register an Agent Under Test

On this page